|
Features:
The Bostitch Finishing Nailer is a pneumatic tool that shoots T headed finish nails to fasten down moldings, casings, door jams, etc.
The N60FN nailer holds finish nail clips of various lengths, from 1-1/4" up to 2-1/2". These are 15 gauge galvanized fasteners
for superior holding power. This is not a brad nailer. unit comes with an attached air pressure regulator for convenient adjustment of
fastener depth. The non-mar rubber tipped foot prevents scratches and the dial a depth fastener control provides for accurate depth placement
of the nail. The air tool requires 2 CFM of air so it may run on almost any small air compressor. The easy load magazine holds
100 nails at a time.
|
|
Specifications:
Fasteners Used: Galvanized 15 Gauge T headed Finish Nails
Fastener Length: From 1-1/4" up to 2-1/2"
Air Requirements: 2 CFM
Tool Weight: 4.6 lbs.
|
Rates:
4 Hours
Day
Week
4 Weeks
|
15.00
22.00
88.00
264.00
|
